The Small Stationary Firewood Boiler Grate must be checked against the foundation plan prior to installation. Check the straightness of the side panels before installing the grate side panels. If a bend is found, it should be straightened. Under the side plate, use iron plate with a length and width of 200mm×180mm as a backing plate to adjust the elevation of the grate side plate (generally, the number of backing plates is not more than 4, and several groups of backing plates are placed under each grate side plate as required.
The Small Stationary Firewood Boiler Grate pad should be placed on the embedded iron of the foundation and directly below the web of the grate side plate). Check the parallelism of the two side panels, check the horizontality above the beam, and check the diagonal of the two side panels. After adjustment, the data detected above must be within the specified range. After the adjustment is completed, the backing plate group is welded into one body with the foundation iron plate and the lower movable plate of the grate side plate. Grout filling between the backing plate group and the backing plate group.
For Small Stationary Firewood Boiler Grate, the ash placing device should be installed flatly on the Z-shaped steel of the lower guide rail. The joint between the bottom plate and the bottom plate should be sealed well. After the air duct is installed, the valve limiter and pull rod should be installed. The ash port should be sealed well, and the pull rod push-pull valve should be flexible. After connecting the air supply duct to the side plate of the grate, connect the ash release lever to the ash dragging device in the air supply duct, and adjust the position so that the ash release valve can slide easily and flexibly; the air regulating plate of the air duct should be rotated. Flexible; there should be no jamming phenomenon; the interface between the tie rod, the air regulating plate and the air supply pipe should be well sealed to reduce air leakage.