According to the requirements shown at each filling hole of the Horizontal Cook Boiler Grate, add lubricant regularly (the bearings on both sides of the driving shaft and the bearings on both sides of the rear axle); other screws and pins that need to be rotated and shaken should also be regularly filled with lubricant. In the first month of operation, the grate must be adjusted and tightened the furnace chain 4 times in 3, 7, 15, and 30 days. If the furnace chain is found to be loose or misaligned, the adjustment screw of the front shaft should be adjusted and tightened in time. stove chain.
When the Horizontal Cook Boiler Grate is disassembled and overhauled, the wear of the sprockets, grate pieces, long pins, front and rear axles, brackets and bottom plates should be checked. If the wear is serious, it should be replaced in time. If the grate deviates, adjust the adjusting bolt on the drive shaft bearing in time. If the grate piece is burnt out or deformed too much, it should be replaced in time (it can be done at the front of the furnace), so as not to affect the safety of operation.
The furnace chain should be tightened to prevent the grate surface from arching and failure, especially when running in a hot state for a long time. Thermal expansion will cause the elongation of the furnace chain. The chain is tight. If the furnace is shut down for a long time, the remaining coal in the coal hopper should be removed; the anti-corrosion agent should be applied to each rotating part.