The start and stop of the Industrial Belt Flexible Conveyor, the industrial belt conveyor should generally be started under no-load conditions. If multiple belt conveyors need to be installed sequentially, a shut-off starter device is required to start and shut down in a certain order as they pass through the central control room. In addition, in the event of an emergency, each conveyor can also have a button to start or stop on the spot, and of course to stop any of them individually. In order to reduce the possibility of longitudinal tearing of the conveyor belt for some reason, when the length of the conveyor exceeds 30m, a stop button is installed along the entire length of the conveyor.
In the maintenance of Industrial Belt Flexible Conveyor, in order to make the industrial belt conveyor run reliably and detect and eliminate possible faults in time, the operator must observe the working condition of the conveyor at any time. If any abnormal situation is found, it should be dealt with in time, and the mechanic should regularly check and check the parts that should be paid attention to. For example, a roller may not be that important, but a high-speed belt conveying abrasive material may wear its shell quickly, so there may be a blade, which can damage the expensive belt. Trained workers or experienced staff can detect the impending accident in time and prevent it from happening.
The belts of the Industrial Belt Flexible Conveyor account for a large percentage of the overall conveyor cost. In order to reduce the cost of repairing and replacing conveyor belts, it is necessary to strengthen the training of operators and maintenance personnel in the operation and maintenance knowledge.